I'm using the default Slider skin in the newest version. I edited the registry to add the latitude and longitude settings for Minneapolis, MN at:
Lat: -93.264
Long: 44.980
These settings now show in the Config.exe program. However, my sunrise and sunset settings are at 06:00 and 06:00. They should be at 7:50 and 4:38 approximately. What additional changes are needed?
Also, am I correct in assuming that the elevation reading is the postion of the sun at the last update time?
Lastly, I'm assuming that the sunrise and sunset readings are for the home location only and that additional latitude and longitude settings cannot be entered for additional weather locations?
Thanks.
-Bob-
Quote from: rebeckerI'm using the default Slider skin in the newest version. I edited the registry to add the latitude and longitude settings for Minneapolis, MN at:
Lat: -93.264
Long: 44.980
These settings now show in the Config.exe program. However, my sunrise and sunset settings are at 06:00 and 06:00. They should be at 7:50 and 4:38 approximately. What additional changes are needed?
Also, am I correct in assuming that the elevation reading is the postion of the sun at the last update time?
Lastly, I'm assuming that the sunrise and sunset readings are for the home location only and that additional latitude and longitude settings cannot be entered for additional weather locations?
Thanks.
-Bob-
I think you have them the wrong way round :D
Minneapolis is Lat 44.980 & Long -93.264
Your other questions: (i) the elevation is the angle of the sun, and is calculated (and constantly changed) by TP - so, if you cycle from one city to the next, then back again (even without a refresh) you'll see that the elevation changes (TP knows that the earth is always rotating!). (ii) You
can enter additional lat/long for other cities - see my post at:
http://www.dark-mojo.com/todayplus/viewtopic.php?t=1056
All the best.....Scotty
Scotty,
Thanks. That was the problem. I guess I should stay away from this wheelbarrel if I don't know how to operate it! :oops:
-Bob-
Bob:
No worries - that's what the forum's here for. :D
I've been on a bunch of fora over the years, and this one is (IMHO) particularly good. The folks are very helpful, & I've learned a lot from reading the various posts.
All the best
Scotty.......
What is a good website for searching city/address latitudes & longitudes?
Quote from: paqqueWhat is a good website for searching city/address latitudes & longitudes?
http://www.heavens-above.com
Click on "Select" under "Anonymous Users" to enter your location information.
Quote from: fishboyhttp://www.heavens-above.com
Click on "Select" under "Anonymous Users" to enter your location information.
Thanks!!!
EDIT: Ok - I've added '38.6580' for my Lat and '77.2500' for my Long, but I can't seem to save the values. The next time I enter Owner Info via config.exe, the fields are empty. How do I save the data?
EDIT2: After inputting the values approx. 237 times, the lat & long finally saved. Is there a better way to commit the config.exe changes other then exiting the application? There are no 'SAVE' buttons on most of the tabs, and the 'Reload Plug-in' on the initial config.exe page doesn't seem to help.
You will have to edit the registry, in order to enter your settings. Create an entry with the name 1 and the data will be. 38.6580,77.2500 then save the entry. Any registry editor will work. I use PHM registry editor which is freeware.