TP does not remember my Lat. and Long.

[Boiler_81]

For some reason TP keeps losing my Lat. and Long. information. Any ideas on why this is happening nad how to fix it? I am using the latest Hammer skin.

[ZapMe1]

For some reason TP keeps losing my Lat. and Long. information. Any ideas on why this is happening nad how to fix it? I am using the latest Hammer skin.

Do you see the Coords set up in the Registry ??

Like This :

[Boiler_81]

For some reason TP keeps losing my Lat. and Long. information. Any ideas on why this is happening nad how to fix it? I am using the latest Hammer skin.

Do you see the Coords set up in the Registry ??

Like This :

Yes, but there are no values

[ZapMe1]

When you set up long/lat before, did you enter them in this section of the registry manually ??

[uk_skinner]

For some reason TP keeps losing my Lat. and Long. information. Any ideas on why this is happening nad how to fix it? I am using the latest Hammer skin.

My experience told me that it is much better to use Registry Editor tool to put them in there.

[Timmy]

When you set up long/lat before, did you enter them in this section of the registry manually ??

I entered them manually in the registry, there was no other way to do it: config.exe didn't do it for me...

Timmy

[ZapMe1]

I entered them manually in the registry, there was no other way to do it: config.exe didn't do it for me...

Same for me !!   I don't seem to have any problems with it anymore...  

[grayme]

I entered them manually in the registry, there was no other way to do it: config.exe didn't do it for me...

Same for me !!   I don't seem to have any problems with it anymore...  

I think I recall a similar error before using confog.exe; wasn't the way around it to make sure that you entered the figures and then clicked on another tab and back to make sure it saved it?

[ZapMe1]

If I make any entries or changes in the registry, I can't close it without being prompted and asked if I would like to save !!

And, of course, I always make a backup before fooling with the registry in the first place !!!!!  

[uk_skinner]

I believed grayme was saying in configure file not in registry key.

[Wichtel]

This already works. You enter your values to the field in the Config, then must click to another field. You then can close the Config and the value is stored.

[ZapMe1]

[Timmy]

This already works. You enter your values to the field in the Config, then must click to another field. You then can close the Config and the value is stored.

Wichtel, thanks for this easy and simple solution!

Timmy

[grayme]

I believed grayme was saying in configure file not in registry key.

Thanks UK, that was my point...  

[Wichtel]

Timmy
No Problem  

For each other City (eg City2, City3 and so on) you must open the Registry and  write the code manually. So you have the Right Lat and Long Value for each City